几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

cracks on brickwall
a horizontal cracks (< 3mm opening) appeared on 70degree sloping brickwall. this 2m (approx) brickwall sits on rc apron around the main building and leans to brickwall of the main building (serve as architectural finishes only). my questions are:
1) are those cracks appeared because of the method of bricklaying (sloping)? or could it be caused from settlement of the apron? what other possibilities in your opinion are the causes of these cracks?
2) what is the best solution?
sounds to me the most likey cause is the slope of the wall. the wall should be designed to resist overturning due to its slope. is it possible to provide a vertical side on one side of the wall so that is section is trianglaur
kieran

2009-09-08, 02:29 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	cracks on brickwall cracks on brickwall a horizontal cracks (< 3mm opening) appeared on 70degree sloping brickwall. this 2m (approx) brickwall sits on rc apron around the main building and leans to brickwall of the main building (serve as architectural finishes only). my questions are: 1) are those cracks appeared because of the method of bricklaying (sloping)? or could it be caused from settlement of the apron? what other possibilities in your opinion are the causes of these cracks? 2) what is the best solution? sounds to me the most likey cause is the slope of the wall. the wall should be designed to resist overturning due to its slope. is it possible to provide a vertical side on one side of the wall so that is section is trianglaur kieran __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]