几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

grouted masonry cells
can anyone point me to a table that gives weights of different thickness cmu walls with various cells grouted (8" oc, 16" oc, 24" oc, 32" oc, etc.)?

there are tables in the back of the reinforced masonry engineering handbook.
also, here
also, i find a lot of helpful information at
thanks guys!
i typically use properties found in ncma tek 14-1a (issued 2003). it breaks down the properties for both average cross-section (stiffness) and net cross-section (stress calculations).
it's also covered in asce7-02 table c3.1 "minimum design dead loads"

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]

2009-09-09, 03:20 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	grouted masonry cells grouted masonry cells can anyone point me to a table that gives weights of different thickness cmu walls with various cells grouted (8" oc, 16" oc, 24" oc, 32" oc, etc.)? there are tables in the back of the reinforced masonry engineering handbook. also, here also, i find a lot of helpful information at thanks guys! i typically use properties found in ncma tek 14-1a (issued 2003). it breaks down the properties for both average cross-section (stiffness) and net cross-section (stress calculations). it's also covered in asce7-02 table c3.1 "minimum design dead loads" __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]