几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

hot rolled vs fabricated member
we are modifying our work shop and all the structural members are planned to be replaced. the existing columns are tapered "i" section.
- could some one suggest if it is ok to fabricate the tapered "i" section columns of about 7 - 8 meter length at site by a-36 plates of the required thickness.
- will this fabricated column have same properties as factory made rolled column.
- what are point of concerns during fabrication of such column
one point of concern is that you can get a lot of distortion by making a built-up
gasprocess...i agree with jstephen on the distortion issue. difficult to control.
in general, built-up members are more likely to contain defects than rolled shapes. rolled shapes are made under controlled conditions and the result is usually quite good.
a lot of pre-engineered metal buildings that i deal with that use tapered built-up sections for columns typically use 50 ksi steel.
thanks guys. i think we will go for rolled sections for the lot.

2009-09-09, 05:09 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	hot rolled vs fabricated member hot rolled vs fabricated member we are modifying our work shop and all the structural members are planned to be replaced. the existing columns are tapered "i" section. - could some one suggest if it is ok to fabricate the tapered "i" section columns of about 7 - 8 meter length at site by a-36 plates of the required thickness. - will this fabricated column have same properties as factory made rolled column. - what are point of concerns during fabrication of such column one point of concern is that you can get a lot of distortion by making a built-up gasprocess...i agree with jstephen on the distortion issue. difficult to control. in general, built-up members are more likely to contain defects than rolled shapes. rolled shapes are made under controlled conditions and the result is usually quite good. a lot of pre-engineered metal buildings that i deal with that use tapered built-up sections for columns typically use 50 ksi steel. thanks guys. i think we will go for rolled sections for the lot. __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]