几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

leaning residential garage
two car garage leaning at the opening end - 20 foot wide, with 1 foot turn at one side and 3 feet at the other. roof is supported to header over the door (this is not the shear wall) - nice high center of gravity, eh?
anyway, any ideas (maybe past expereince) on relatively easy way to straighten/brace this end? simpson shear wall products are not made for retrofits. i was thinking of advising on interior frame.
check out our whitepaper library.
add a steel portal frame of some type at the door opening or,
add a ceiling diaphragm - either with diagonal tie-rods/turnbuckles or plywood sheathing (after plumbing the structure) to make a 3 sided shearwall system or,
add exterior buttresses (may not be feasible or desireable or,
punt.
jae
i was thinkin' of the 1st option you listed, but i sort of like the 2nd option. thanks for the input.

2009-09-10, 10:03 AM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	leaning residential garage leaning residential garage two car garage leaning at the opening end - 20 foot wide, with 1 foot turn at one side and 3 feet at the other. roof is supported to header over the door (this is not the shear wall) - nice high center of gravity, eh? anyway, any ideas (maybe past expereince) on relatively easy way to straighten/brace this end? simpson shear wall products are not made for retrofits. i was thinking of advising on interior frame. check out our whitepaper library. add a steel portal frame of some type at the door opening or, add a ceiling diaphragm - either with diagonal tie-rods/turnbuckles or plywood sheathing (after plumbing the structure) to make a 3 sided shearwall system or, add exterior buttresses (may not be feasible or desireable or, punt. jae i was thinkin' of the 1st option you listed, but i sort of like the 2nd option. thanks for the input. __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]