几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

umbrella roof for api-650 tanks
good day ya'll.
i'm specking an api-650 type tank to hold potable water. i understand what a dome and cone roof would look like, but the spec's description of an umbrella roof is a little vague. does anybody have a source for what one of these roofs would look like, or how they're constructed. this is for a small tank, 40' diameter, the design will call for a self supporting roof.

it looks just like a dome from the ground but the roof sheets are only rolled in one direction. it's like if you cut long thin triangles say about 6 feet on one end and 6" on the other end, long enough to reach nearly to the tank center from the edge, then rolled them the long way. installed with laps on their long edges.
thanks ifr,
i can envision what your talking about it.

2009-09-16, 04:55 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	umbrella roof for api-650 tanks umbrella roof for api-650 tanks good day ya'll. i'm specking an api-650 type tank to hold potable water. i understand what a dome and cone roof would look like, but the spec's description of an umbrella roof is a little vague. does anybody have a source for what one of these roofs would look like, or how they're constructed. this is for a small tank, 40' diameter, the design will call for a self supporting roof. it looks just like a dome from the ground but the roof sheets are only rolled in one direction. it's like if you cut long thin triangles say about 6 feet on one end and 6" on the other end, long enough to reach nearly to the tank center from the edge, then rolled them the long way. installed with laps on their long edges. thanks ifr, i can envision what your talking about it. __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]