几何尺寸与公差论坛------致力于产品几何量公差标准GD&T (GDT:ASME)|New GPS(ISO)研究/CAD设计/CAM加工/CMM测量 - 查看单个帖子

wind load cases and combinations
asce7-05 fig 6-9 design wind load cases state "pressures acting on the projected area perpendicular to each principal axis". does this mean roof pressures are not included?
in addition, while it seems reasonable to ignore side wall pressures since they counteract each other, they can be a factor in the combined directions of case 3 and 4.
any input is appreciated.

find a job or post a job opening
if you're tlaking about flat (horizontal) roofs, then yes (as the projected area is zero).
personally, i'd've thought the wind loads on the sides of buildings would apply loads to the horizontal partsof the building (roofs, floors), as these react the side loads.
yes, flat roof buildings.
side loads could apply for component cladding although unlikely but are not part of the mwfrs cases in figure 6-9, correct.
but won't a flat roof have a different wind loading ... suction, the reduction in static pressure when you've got a 100 mph (or whatever) wind blowing outside ?
yes, a flat roof will have suction or uplift. but my question is that figure 6-9 mwfrs load cases ignore it, correct?
how many principal axis does a rectangle has?

2009-09-16, 09:41 PM	#1
huangyhg 超级版主注册日期: 04-03 帖子: 18592 精华: 36 现金: 249466 标准币资产: 1080358888 标准币	wind load cases and combinations wind load cases and combinations asce7-05 fig 6-9 design wind load cases state "pressures acting on the projected area perpendicular to each principal axis". does this mean roof pressures are not included? in addition, while it seems reasonable to ignore side wall pressures since they counteract each other, they can be a factor in the combined directions of case 3 and 4. any input is appreciated. find a job or post a job opening if you're tlaking about flat (horizontal) roofs, then yes (as the projected area is zero). personally, i'd've thought the wind loads on the sides of buildings would apply loads to the horizontal partsof the building (roofs, floors), as these react the side loads. yes, flat roof buildings. side loads could apply for component cladding although unlikely but are not part of the mwfrs cases in figure 6-9, correct. but won't a flat roof have a different wind loading ... suction, the reduction in static pressure when you've got a 100 mph (or whatever) wind blowing outside ? yes, a flat roof will have suction or uplift. but my question is that figure 6-9 mwfrs load cases ignore it, correct? how many principal axis does a rectangle has? __________________ 借用达朗贝尔的名言：前进吧，你会得到信心! [url="http://www.dimcax.com"]几何尺寸与公差标准[/url]