huangyhg

unbalanced layup
is composite wing mainly of quasi layup construction? and is it only for the only skins or the stiffeners like spars, ribs and stringers. i came across a presentation mentioning using unbalanced layup on the wing design to overcome the twisting, is this just simply add on extra plies on a quasi layup skins??
eng-tips forums is member supported.
no, wing skin layups are typically biased towards having more fibers in the primary load carrying direction; i.e., spanwise. unbalanced means there are an unequal number of +45 and -45 plies, which induces twisting of the wing when it bends in the spanwise direction. this bending-twist coupling can be used to counteract aerodynamic induced twisting of the wing.
"unbalanced means there are an unequal number of +45 and -45 plies"
well in fact any unequal number of off-axis plies (except 90s of course). you get unbalanced layups with unequal numbers of +30, -30 plies for example.
a/c box skins (wing, tailplane, fin) might be as much as 60% spanwise fibre in some places. this needs unidirectional material (unbiased all cloth layups can be at most 50% 0 degree). such a skin might vary between 40% and 60% spanwise. it depends on the other forces in the box. +-45 degree plies need to be present to take box torsion. typical percentages might be 30 to 50%. chordwise fibres are needed as well, particularly near significant load inputs such as trailing edge control surface hinges and actuators. skin stiffeners can be more 0 degree, as they don't need as many angle plies or 90 degree ones.
spar webs need lots of 45 degree plies. ribs need a good mix, with (usually) quite a few fibres in the vertical direction to resist brazier crushing loads and tension due to over-fuel pressures and crash pressures.
before the aerodynamic effects of gross structural coupling between incidence and torsion were understood some terribly dangerous monoplanes were designed. in wwi quite a few german pilots were killed by such effects.
deliberate material-based bend-twist coupling was probably most famously used on the x29 with its forward swept wing.
while you can achieve such coupling with uneven numbers of + and - angle plies, it can also be done by using the distribution through the thickness and to keep the same number in each direction. (this is probably more practical for a more monolithic structure than a box.) just put all the +angle plies nearer the centerline of the beam than the -ones (or vice versa, depending on what you're trying to do). under bending, the +plies above the neutral axis try to shear one way and those below it shear the other (giving twist). the same goes for the -plies, giving twist in the opposite direction. however, the plies furthest away from the neutral axis are more effective, giving a nett twist in their direction.

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]