huangyhg

thermocouples
anyone familiar with the installation of thermocouples in mass concrete to measure temperatures of the core and the edge? any recommendations for data loggers for this operation?
dik
find a job or post a job opening
i have no experience in the area but have you tried aci 207, which deals with mass placement? they might have something.
the earlier thread on this is
thanks, zambo and bridgebuster...
i picked up a couple of the data loggers for measuring the temperature of the enclosure and they work incredibly well. i need to determine the temperature of the mass within and thermocouples along with a logger seemed to be the way to go...
dik
dik,
i too have a job where 1.5m reinforced concrete raft to be done. i've been searching this for some time. can you please forward me what you found and that would be very helpful?
clefcon
these pours are about 2.5m x 12m x 10m with 35mpa concrete (i didn't design them, so don't know the reason for the higher strength (might be durability). the mix uses about 25% ash and has a 4" (90+/-30) slump. i have a couple of files (*.pdf), one a report and the other some info on thermocouples. check my forum lists for my interests.
dik
thanks a lot.
clefcon
we have used the intellirock system for thermal management monitoring on several mass concrete projects. more information on this system can be found at
gregory...
very good link.
dik

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]