huangyhg

Has anyone had a program lose the line that says "End of dimension" after True position and location dimensions?

Halfway through the reporting section of a program I have lost these "end of dimension" lines.

The problem is the dimension stays open so if i hit enter at the end of the dimension it just keeps adding more axis. I can not insert dimension's, comments,alignments,variables...nothing! in this area of the program "No legal insertion point below" is the message i get. This goes on for the last 3000 lines of the program.

Currently I am re-dimensioning this section(Which will take a day or two...aargh!) of the program & curious to know why or how this happened.

Any comments?

I just realized i posted this in the code forum.....Sorry about that..

huangyhg

Spaz,

I know this is an old post, but if you didn't get it by now there's a vb file on the wilcox site that you can dowload and run and it automaticly puts the end of dimension back in. You have to register to get access to it.
Sinned

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]