yang686526

can't see objects in some file
can't see objects in some file
hi guys.
i've got a problem in opening some dwg file.(attached file)
my application can display only paperspace's layout. but all objects in this file are disappear.
these happen as same as when open this file with singledocapp example.
but not in odamfcapp,they seem very fine when open with.
i doubt that why my app can open another dwg file normaly except this one.
i think that might be something wrong with active viewport?
or did i do something wrong? and how to make they display normaly?
thanks a lot.
attached files
i see that in 2.2 singledoc displays the drawing correctly.
both autocad and odamfcapp display only lower-left corner of the drawing untill zoom extents is performed. (singledoc performs zoom extents immediately after opening the file).
sergey slezkin
hi there,
i've updated to dd 2.2 but singledoc(debug mode)
still can't display objects anyway.
it can displays only paperspace and offset lines.
any suggestion?
last edited by parinya; 19th december 2006 at 01:57 amfff">. reason: miss typing
opps.. sorry. that was my misstake in including lib dbg folder.
now i can open that file with singledoc. but just only in debug mode.
i wonder why i have to set enablegsmodel to "false"
to make this file displays correctly in release mode?
otherwise, they will be not display objects in singledoc neither in odamfcapp.
could somebody explain that?
which objects are missing? attached is screenshot for singledoc release immediately after opening the file.
attached images (169.9 kb, 10 views)

sergey slezkin
hi slezkin
in release mode.
from this captured figure. you will see only sheet.
but after set enablegsmodel(false). all objects are back to normally.
so i wonder why it have to set that?
caz i'm afraid it might be somethingelse has effect to my work.
thanks a lot
attached images (12.1 kb, 7 views)

last edited by parinya; 20th december 2006 at 08:34 pmfff">.
my screenshot was made after opening the file in singledoc.exe release built from binary distribution with msvc6.
(btw, the vc6 project by mistake puts output release .exe file to debug folder - i fixed it).
i think singledoc does not allow setting usegsmodel on/off.
which compiler do you use?
sergey slezkin
i'm using msvc.net 2003.
btw. i can set enablegsmodel without any warning
i reproduced the problem in msvc2003 singledoc release and in odamfcapp.exe release.
(in msvc6 everything is ok and msvc2003 odamfcappdll release is ok too.)
sergey slezkin