huangyhg

z dimension
i have a dimension on a drawing called out as "z 8", it points to the edge of the part. this is on a part that is protruding from the inside of a cylinder. any idea what this means?
find a job or post a job opening
is the part tapered? the lowercase z translates into a taper symbol when the aigdt font is used.
powerhound
production supervisor
inventor 11
mastercam x
smartcam 11.1
ssg, u.s. army
taji, iraq oif ii
it doesn't appear to be. although it could be a taper between the id of the cylinder and the lug. the lug is a tab on the inside on the unit about 4" wide by 1" think. the callout is pointing to the line where the lug meets the id.
i will check out the taper symbols. you may be on to something. thanks.
promoting, selling, recruiting and student posting
are not allowed in the forums.
(add stickiness to your site by linking to this professionally managed technical forum)
title: drafting standards,
description: drafting standards, gd&t & tolerance analysis technical support forum and mutual help system for engineering professionals. selling and recruiting forbidden.

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]