huangyhg

foreign steel sections
hi all,
i'm designing a portal frame & my client told me to use some steel sections from australia.
what conversions do i need to do to perform in order for me to use the foreign sections?
our ultimate limit state factors is 1.4d + 1.7l & i was told australia code is similar to canadian code which adopts 1.25d + 1.5l.
i believe there is no problem in section size & section modulus. what about yield strength & material factor?
thanks

often, it is a cost factor when deciding where to obtain strucural steel. steel from a mil that is not in the united states may offer structural steel at a lower price; however, it may well be a lower cost only because of less stringent quality control guidelines.
when dealing with steel materials from a mil that is not in the united states, re
i think the pdf at this link is the one that lists all the section properties including yield and ultimate strengths. if not, please persevere, its somewhere there, but i do not find it a friendly site.
i agree with pxc's comment that you will need to design your structure to suit your local/national requirements, so all you will need are the material and sectional properties.
most australian section are "grade 300 plus" (yield strength of 300 to 320 mpa). some older sections are "grade 250" (250 to 260 mpa), so be careful that your sections are not old stock.
download information on chemical composition, material properties and section properties for australian sections at
in answer to you question, typical ultimate load cases in australia are 1.2d + 1.5l (+ w), for maximum gravity load, and 0.9d + 1.5l (+ w), for stability in overturning (ref. as1170). this is used in conjuction with a material reduction factor of 0.9 for structural steel (ref. as4100), so the nett effect is similar to your 1.4d + 1.7l (+ w).
just a note to support rlflower,
sections obtained from overseas should be carefully checked for rolling defects and conformity to the tolerances of the destination country.
we have just recently completed construction of a large steel structure with out of country rolled shapes and rejected several peices for roll defects, including one beam which had a longitudinal crack along the junction of the web and flange.
good luck
dutchie
the australian steel production and fabrication industries are world class. in 2001:
鈥?nbsp; australia produced 0.8% of the world鈥檚 steel
鈥?nbsp; australia was ranked number 22 in world production
鈥?nbsp; onesteel, australia鈥檚 major producer, was the world鈥檚 29th biggest steel producer
鈥?nbsp; australia produced 3% of the world鈥檚 dri/hbi
鈥?nbsp; australia contributed 19% of the world鈥檚 dri/hbi shipments
鈥?nbsp; australia is the world鈥檚 largest exporter of iron ore
source: australian government; department of industry, tourism and resources (
hi all,
thanks for the input.
p/s: i was wondering anyone here who has experience working in far east; i'd appreciate if anyone can share his/her experience.

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]