huangyhg

shrinkage in concrete
hi all
i ask a question ,i am afarid that it is a simple question and from basics of concrete design,(but anyway)
what is meant by shrinkage of concrete?
and when it happend?
find a job or post a job opening
concrete shrinks as it cures. majority of shrinkage takes place very early in the cure cycle. many things (mix design and amount of water among others) affect the amount of shrinkage.
concrete consists of aggregate particles dispersed in a cement paste. paste shrinkage is an order-of-magnitude greater than aggregate shrinkage, so the system finds equilibrium with the aggregate in compression offering restraint to the paste shrinkage. the paste is in tension and will crack in regions of stress concentration.
try the portland cemen association's website for additional technical information about concrete
thanks all for your help, so shrinkage of concrete results tension cracks in concrete beams for example, and if the beam depth incrase the surrface(depth) subjected to shrinkage will have more lenght which will lead us to use some side bars (distrubted over beam depth) to resist this tension force
am i right in what i said?
yes, this is correct. the reinforcement does tend to hold the cracks together. aci 318-02, section 10.6.7 gives requirements for this reinforcement.
well that is the commentry of aci 318-02,section(r10.6.7)
temperature and shrinkage cracking happens to all concrete members. for other
i will throw a spanner into the works here.
linear shrinkage of concrete does not induce any stresses or cracking in concrete.
restraint to the shrinkage of concrete induces stresses in the concrete. this restraint can be caused by connection to other elements which will not allow the concrete
well rapt thank you so much for your reply
but i do not understand a point.
how can reinforcement make cracks in the concrete?!
does shrinkage occur on the sides of thick footings and thick mats?
dawn836
when the concrete shrinks the reinforcement that is bonded to it goes into compression because it does not shrink itself. the two materials are bonded together so if the concrete shortens due to shrinkage then the reinforcement must shorten by the same amount. to shorten the reinfrocement must experience a compressive stress. this compression induces an equal and opposite tension stress in the concrete. if the reinforcement is not arranged symmetrically in the section, it will also induce bending stress due to the eccentricity of the compression stresses.
while this tensile stress itself would not normally be sufficient to crack the concrete unless the reinforcement ratio is very large, when combined with other tensile stresses from loading or other effects it could be sufficient to cause a supposedly uncracked concrete section to crack.

__________________
借用达朗贝尔的名言：前进吧，你会得到信心!
[url="http://www.dimcax.com"]几何尺寸与公差标准[/url]